OmniSistem PR XL 250 - Manual (Page 7)

7/24
STAND-ALONE MODE
Operate the projector without connecting a controller, enable the master mode in the operation panel, the
projector will run in Stand-Alone mode automatically.
MASTER/SLAVE MODE
Without using a controller, many projectors can run synchronously in the Master/Slave mode by linking them
with each other. Select one projector as the master with setting options master mode enabled but slaves.
Regard the other projectors as the slaves with setting options slave mode enabled and all DMX start
address “001”.
Connect the controller’s output to the first fixture’s input, and connect the first fixture’s output to the second fixture’s input
and connect the rest fixtures in the same way. Eventually connect the last fixture’s output to a DMX terminator as shown
in the figure below.