Chauvet 200B - Manual (Page 7)

LED-PAR200B User Manual 7 2010-03-09/15:03
4. O
PERATING
I
NSTRUCTIONS
The LEDsplash™ 200B is a DMX controllable, full RGB color mix par can made up of highly efficient
and super bright LEDs. All red, green and blue LEDs can be controlled separately allowing the
creation of an unlimited range of colors.
The LEDsplash™ 200B can operate in Stand-Alone, Master/Slave and via DMX-512 control utilizing
six DMX channels.
Master/Slave Mode
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode.
1) Set dipswitches position to Sound Active or Auto Mode.
Mode Dipswitches
Sound Active 1~10 = Off, switch set to Music
Auto Mode 1~10 = Off, switch set to Auto
2) The unit will react to the low frequencies of music via the internal microphone in Sound Active
mode, or the unit will auto change in Auto Mode.
3) Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Sound-Active mode. Turning the knob counterclockwise decreases the sensitivity; turning the
knob clockwise increases the sensitivity.
Daisy Chain Connection
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3-pin
connector to the input connector of the next fixture consisting of a (male) 3-pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
DIP Switch Options
F UNCTIONS DIP SWITCHES ( ON ) N OTES & D ESCRIPTION
Color change program
(Auto/Music)
None
Music/Auto switch
Music: Sound-Activated, sound adjustment knob sets
sensitivity
Auto: sound adjustment know sets speed of program
Red LEDs
1 Low Intensity
2 Medium Intensity
3 Full Intensity
Green LEDs
4 Low Intensity
5 Medium Intensity
6 Full Intensity
Blue LEDs
7 Low Intensity
8 Medium Intensity
9 Full Intensity