Philips QG3270-41 - Manual (Page 6)

Hair Clipping
I Use this Groomer for its intended household
use as described in this manual.
> Make sure that the Groomer is fully charged
before you start clipping. This Groomer will
not operate while cord is connected to
electrical outlet.
I Before you start clipping, make sure that the
head of the person whose hair you are cutting
is at the same level as your chest so that all
parts of his/her head are clearly visible and
within easy reach.
I Make sure hair is clean and dry.
I Before you begin, comb the hair in the
direction of growth (fig. 4).
> To achieve optimal clipping results, always move
the appliance slowly through the hair against
the direction of hair growth.
Do not move the Groomer too fast. Make smooth
and gentle movements.
Clipping with hair clipping comb
II Put the hair clipper on Groomer handle
(fig. 5). You will hear a ‘click’.
B Slide the hair clipping comb into the guiding
grooves on both sides of Groomer handle
and push until you hear it‘click’ into place
(fig-6)-
B Press the Hair Length Setting Selector (I)
and slide it to the desired setting (2) (fig. 7).
See Table I for settings.
□ The setting selected will appear on the back
of the Groomer.
When you are clipping for the first time, start
at the maximum clipping length setting (#6) to
familiarize yourself with the appliance and pre­
vent accidentally trimming hairs too short. As you
become familiar with the settings, adjust the Hair
Length Setting Selector to desired trimming length.
Selector will 'click' into position at each setting.
Table 1. Hair Clipper
Barber Setting Remaining hair length
(in.)/(mm)
#1 1/8 in/3mm
•
3/16 in/5mm
#2 9/32 in/7mm
#3
3/8 ln/9ntim
• 7/16 in/l Imm
#4 1 /2 in/13mm
#5 5/8 in/15mm
•
Il/I6in/I7mm
#6 3/4 in/19mm
B Switch the Grooomer ON (fig. 8).
□ Make sure that the flat part of the comb is
always in full contact with the scalp to obtain
an even result (fig. 9).
B
Move the appliance slowly over the crown
from different directions to achieve an even
result (fig. 10).
B Always move the appliance against the
direction of hair growth. Press lightly.
B
Make overlapping passes over the head to
ensure that all hair that should be cut has
been cut.
\E
Turn the Groomer off and remove the hair
clipping comb often to blow and/or shake
out hair that has accumulated.
> REMEMBER:You must reset the hair length
selector back to your desired setting every
time you replace the hair clipping comb on the
appliance.
TIP: Write down the settings you have used to create
a certain hairstyle as a reminder for future clipping
sessions.