Wiring techniques, Name of parts, Wiring techniques name of parts – Clarion DVH940N User Manual
Page 11: 11 english, Use when connecting optional control unit (dvc920)
DVH940
11
English
6. WIRING TECHNIQUES
Name of Parts
SLAVE
STAND
ALONE
1
CeNET connectors
Connect to center unit using CeNET cable.
2
Front RCA output connectors
Connect to external power amplifier using
RCA pin cable.
3
Rear RCA output connectors
Connect to external power amplifier using
RCA pin cable.
4
Sub-woofer RCA output connectors
Connect to external power amplifier using
RCA pin cable.
5
Center speaker RCA output connectors
Connect to external power amplifier using
RCA pin cable.
6
Digital input connector
Connect to DVD/CD changer using optical
digital cable (sold separately or included).
* Connect to black connector side
7
Cable clip hole
Insert cable clip to hold optical digital cable in
place.
8
RESET switch
Press to reset circuitry if no sound is
produced.
Note:
• Be sure the CeNET cable is connected when
pressing the [RESET] switch.
Use When Connecting Optional
Control Unit (DVC920)
9
[STAND-ALONE / SLAVE] switch
• Set to STAND ALONE when connecting
a control unit.
• Leave at SLAVE position when no
control unit is connected.
0
Analog input connectors (RCA)
Connect to center unit’s RCA 2ch output.
Note:
• The following are enabled only when a
control unit is connected.
!
Control unit 8P mini DIN plug
Connect to control unit.
@
Control unit power connector
Connect control unit’s power cable here.
* Leave tape in place when not in use.
[STAND-ALONE/SLAVE] switch
* The factory default setting is
SLAVE position.