Canon C2550 - Manual (Page 44)

TCP/IP Network Setup Procedures 3-2
3
Usin
g a
TCP/IP Netw
or
k
TCP/IP Network Setup Procedures
To use a TCP/IP network, it is necessary to perform the following procedures.
1
Protocol Settings (See "Protocol Settings," on p. 3-3.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
Canon utilities (NetSpot Device Installer, etc.)
2
Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/
Sending a Fax," on p. 3-43.)
Specify the settings for each computer you use for printing or sending a fax. (Optional equipment is required
to print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
3
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 3-54.)
Specify the settings of the computer receiving data sent from the machine.
IMPORTANT
• If you are using the optional imagePASS, for step 2, see the manual provided with the
optional imagePASS, not this guide.
• It is recommended that steps 1 and 3 above be performed by the network administrator.
• The machine or optional printing equipment does not come with printer driver software
that can be used on a UNIX platform. (Use LPD to set up a printer in UNIX.)
• As the fax option does not come with fax driver software for the UNIX platform, it is not
possible to send a fax from a UNIX platform.