Cobra Electronics XRS 9955 - Manual (Page 7)

Nothing Comes Close to a Cobra ® 9
8 English
Getting Started Getting Started
Standby Screens
•
Press Mute while the down arrowhead is displayed at the top center of
any Standby screen to cycle through and select a different screen.
The Standby screens will be displayed in the following order:
NOTE
Compass will only show if either the
magnetic compass in the detector
unit is turned On and calibrated
or the Optional GPS Locator unit
is installed and receiving a signal.
Speed and and Latitude/Longitude
(marked with an *) will display
only if the Optional GPS Locator
unit is installed and receiving
a signal.
NOTE
Last Standby screen viewed
will be displayed when exiting
Display Timeout mode.
Your Detector Your Detector
Main Standby Screen
Displays the maximum possible information about the
detector and its settings. The GPS icon will show only if
the Optional GPS Locator unit is connected.
I-Mute or I-Mute Pro and City or Hwy Mode
Displays the status of alert filtering (City mode) and
automatic muting (IntelliMute or IntelliMute Pro mode).
See pages 17 and 18 to set these features.
Car Voltage
Displays voltage level of your car battery. See page 24
for Voltage Warning information.
Compass
The compass indicates driving direction if either the
magnetic compass in the detector unit is turned On
and calibrated or the Optional GPS Locator unit is
installed and receiving a signal. If neither is active,
the center of the compass icon will show two bars.
Speed
If the Optional GPS Locator unit is installed and receiving
a signal, the vehicle's speed will be shown. (You can
select mph or km/h in Menu mode.) See page 35 for
Speed Alert information.
Lat/Lon
If the Optional GPS Locator unit is installed and receiving
a signal, the vehicle's present location will be shown.
Main Standby
Screen
Speed
Car Voltage
I-Mute/I-Mute Pro
City/Hwy Mode
Latitude/Longitude
Compass
*
*