Chief Manufacturing Flat Panel Display Security Kit KSA-1009 - Manual (Page 6)

Installation Instructions FSA/KSA-1009
6
INSTALL SECURITY SET SCREWS
The security set screw is used to secure the pivot-pitch
wall mount. You will need the security hex keys
(provided) to install the security set screws.
There are two different wall plates, which require
different security requirements. Select the option that
applies to your configuration.
Option I
NOTE: If your wall plate uses a 1/4-20 set screw,
replace it with a 1/4-20 x 5/8” security set screw
(40) and a 1/4-20 x 1/4” security screw (30).
The existing set screw in the wall plate is too
long to be used with the 1/4-20 x 1/4” security
screw.
1. Verify that you have the correct parts.
2. Remove the existing 1/4-20 x 1/4” set screw from the
wall plate.
3. Install a 1/4-20 x 5/8” security set screw (40) and a
1/4-20 x 1/4” security screw (30) into the wall plate in
the order shown in Figure 6.
Option II
1. Verify that you have the correct parts.
2. Remove the existing 5/16-18 x 3/4” set screw from
the wall plate.
3. Install the 5/16-18 x 3/4” security screw (50) in the
wall plate (see Figure 7).
Figure 6. Install Security Set Screws (Option I)
Figure 7. Install Security Set Screws (Option II)
1/4-20 x .625
Set Screw
1/4-20 x .25
Security Screw
5/16-18 x .75
Security
Set Screw