Chief Manufacturing Truss Pitch-Adjustable Mount TPP - Manual (Page 5)

4
Instruction Manual TPP
6. Install the face plate in the desired position (see Figure 4, Fig-
ure 5, Figure 6 and Figure 7) on the pitch-adjustable plate and
secure using two 3/8-16 Nylock nuts and washers in any
matching set of radial holes slotted to allow slight roll adjust-
ment.
Figure 4. Vertical Tilt Shown without Back Plate for Clarity
Figure 5. Horizontal Tilt Shown without Back Plate for Clarity
3/8-16 Nylock Nuts and Washers
Figure 6. Vertical Truss Shown with Back Plate Figure 7. Horizontal Truss Shown with Back Plate