CLIFFORD Falcon II - Manual (Page 15)

Feature
Factory
setting
# of
flicks and
chirps
Secondary
action
Program
completion
confirmation
Result
Add a New
Remote to
Channel 3
(silent
arm/disarm)
— 15 Press remote control button III 3 chirps
Buttons III/channel 3 code
of the new remote control
has been memorised
Add a New
Remote to
Channel 4
(optional
remote
accessory)
— 16 Press remote control button IV 4 chirps
Button IV/channel 4 code
of the new remote control
has been memorised
Add a New
Remote to
Channel 5
(remote
controlled
valet mode)
1sec. 17
With the red side switch in the
DOWN position, press button I
5 chirps
Channel 5/remote valet code
of the new remote control
has been memorised
Erase all
channels
— 19 — 2 chirps
All channels have been
erased, program in new
remote control(s)
Adding new remote controls
For other drivers in your family, or if you wish to control Falcon II systems on your
other cars with the same remote control, you can buy additional remote controls
from any Authorised Clifford Dealer and program them into the system yourself.
Each Falcon II will respond to as many as four 4-button/12-channel Premier and/or
ACG remote controls. To add a new remote control to the system, use the
procedures noted in the User-selectable features section on pages 13-14.
Programming Example
To change the AutoArming feature from its factory setting of “on” to “off,” you
would do the following:
•
Turn the ignition key to the ON position.
•
Flick the valet switch back and forth 4 times (stop when you hear the 4th chirp).
•
Wait 3 seconds. You will hear one more chirp to confirm that the AutoArming
setting is now off.
•
Turn the ignition off. That’s all there is to it!
14