Canon MultiPASS Printer C755 - Manual (Page 4)

Made in Japan Made in Japan Made in Japan Made in Japan
PUSH PUSH PUSH PUSH
Ink Tank
BCI-3C
Ink Tank
BCI-3M
Ink Tank
BCI-3Y
Ink Tank
BCI-3BK
Black Cyan Magenta Yellow
4
Install the BJ Tanks
5
Load a Stack of Paper
1
2
3
4
5
6
Twist off the orange
protective cap.
To prevent spills,
do not press
the side of
the BJ tank.
Insert the
yellow BJ
tank into the
right slot of
the cartridge.
Press down
on the top of
the BJ tank
until it locks
into place.
Install the other
3 BJ tanks
as shown.
Magenta (BCI-3eM)
Yellow (BCI-3eY)
Close the ADF cover.
When the ALARM light stops flashing,
the printer is ready.
Pick up the yellow BJ tank.
Pull up the
orange tape.
Remove the
plastic wrapper
from the tank.
Black (BCI-3eBK)
Cyan (BCI-3eC)
Pull the paper rest up until it stops.
Move the paper guide to the left
to match the size
of your paper.
Fan a stack of paper. Fan the edge that will feed
into the MultiPASS first; then tap the stack on
a flat surface to even its edges.
Insert the stack of paper.
Do not fill the sheet feeder above
the limit mark ( ). The sheet feeder
holds up to 100 sheets of plain
paper (20 lb or 75 g/m 2 ).
Adjust the paper guide snugly against the side
of the stack of paper.
Make sure the print side of the paper is face-up.
Align the right edge of
the stack with the right
side of the sheet feeder.
The sheet feeder is the larger capacity tray
behind the ADF.
1
2
Sheet Feeder
(holds blank paper
for printing or
receiving faxes)
ADF
(holds documents
to be faxed, copied,
or scanned)
Paper limit mark
No gaps
here
Tab
Sheet Feeder
InkTank BCI-3M
Yellow
Made in Japan PUSH
PUSH
InkTa BCI-
Yellow
Made in Japan PUSH