Compaq HB1004 - Manual (Page 25)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-7
Compaq HB1004 10Base-T Hub User Guide
Writer: Weldon W. Rowan Project: Setup and Configuration Comments:
File Name:SAB_3.DOC Last Saved On:7/2/98 4:53 PM
Once the connection is established, the Main Menu for out-of-band
configuration appears as shown in Figure 3-6.
Figure 3-6 Main Menu
4. Select any of the displayed menu items as described in the following
section. Table 3-1 describes each of the Main Menu items.
Compaq HB1004 System
Configuration
The Compaq HB1004 provides a proprietary, user-friendly, menu driven out-
of-band program (Compaq HB1004 System Configuration Program). This
program allows you to configure the hub using a PC directly attached to the
RS232 port on the front of the hub,
or remotely via a modem connected to the
RS232 port. With this program you can define system parameters, manage and
control the hub and associated ports, and monitor network conditions. Table 3-1
briefly describes the menu selections available for this program.