Philips FW48-37 - Manual (Page 17)

CASSEHE DECK CD CHANGER
Dubbingcassettes(fromTAPEDECK2toTAPEDECKi) General Information
1 Load the pre-recorded cassette into tape deck 2 and a
blank cassette into tape deck 1.
-♦ Make sure that both cassettes have their full spools
to the left.
• For high speed recording, press
HIGH SPEED DUBBING.
-• HIGH SPEEO appears on the display.
2 Press PAUSE on tape deck 1.
3 Press RECORD on tape deck 1.
-* RECORD appears on the display.
4 Press PLAY ►on tape deck 2.
— Recording will start automatically.
5 Press STOP'OPEN on tape deck 1 and tape deck 2
to stop dubbing.
Notes:
At the end of side A, flip the cassettes to side B and
repeat the procedure. The tape deck does not have an
auto-reverse function, so you must manually flip the
cassette.
Dubbing of cassettes is only possible in the Tape
mode. To ensure good dubbing, use cassettes of the
same length.
During high speed dubbing operation in the Tape
mode, the sound is reduced to a low volume.
For recording, use only a cassette of lEC type I (normal
cassette).
The tape in the cassette is secured at both ends with
ieader tape. At the beginning and end of a cassette,
nothing will be recorded for six to seven seconds.
The recording levei is set automaticaliy, regardless of
the position of VOLUME.
Check and tighten siack tape with a pencil before use.
Slack tape may get jammed or may burst in the
mechanism.
To prevent accidental recording, break out the tab on
the left shoulder of the cassette side you want to
protect. To re-record the cassette, cover each hole with
cellophane tape.
Erasure Prevention Tabs
Warning!
1) This set is designed for conventionai CDs. Do not use
any accessories like disc stabilizer rings or CD
treatment sheets, etc, which may damage the CD
mechanism.
2) Do not load more than one disc into each tray.
3) When the CD changer is loaded with CD(s), do not turn
over or shake the unit as this may jam the changer
mechanism.
You can ioad up to three discs in the CD changer for
continuous play without interruption, in addition to the
conventional 12-cm disc, 8-cm discs can also be used
without an adaptor.
Loading the CD Changer
C-120 tape is extremeiy thin and may be easily
deformed or damaged. It is not recommended for use in
this unit.
Store the cassettes at room temperature and do not put
them too close to a magnetic field (for example,
transformers, TVs or speakers).
CD.
2 Press OPEN»CLDSE.
-* The CD compartment slides out.
3 Load a disc with the printed side op in the right tray.
• You can load another disc in the left tray.
17