Cobra Electronics XRS 9700 - Manual (Page 12)

Program/Mute Button
Select/Dim Button
Set/City
Button
Nothing comes close to a Cobra ® 19
Settings
Your Detector
18 English
Pop Alert
Pop Alert will alert you of Pop radar signals. During the alert, the unit
continues to detect other signals. The factory setting is Pop Detect off.
To Turn Pop Detect Mode On Or Off Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode,
go to Pop Detect. Tone Visual Display Voice
Two (2) beeps Pop On Ka Pop On
One (1) beep Pop Off Ka Pop Off
Pop Detect On
Pop On
Pop Detect Off
Pop Off
Settings
Your Detector
NOTE
If you do not press the Set/City button within two (2) minutes after beginning
the set compass process, compass calibration will automatically terminate.
To Calibrate The Compass Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode, go to
Set Compass. Tone Visual Display Voice
None Set Compass None
Press and hold the Set/City button
to begin setting the compass. One (1) beep Drive in 2
circles…
Press SET
when done… Set Compass
Within two (2) minutes, drive your
vehicle in a circle twice, then press
the Set/City button again. Three (3)
beeps Compass Set!
For two (2)
seconds
followed by
direction of
travel (
N, NE,
E, SE, S, SW,
W or NW)
Compass Set
Press and release either the Select/Dim
button to proceed to the next user
mode or the Program/Mute button
to exit Program mode. None None None
Set Compass
Set Compa...
Calibrate
Compass
Drive in...
Compass Set
Compass
Press SET... Set!
Direction
Of Travel
N W h
Tone Visual Display Voice
One (1) beep Compass not set…
Please try again…
Compass not set…
Please try again…
Compass n...
Please tr...
Terminate