Philips FWR7R37 - Manual (Page 53)

TUNER
oz
O’
t
'U
.-A
|Tuning to radio stations
1 Press TUNER to select the tuner.
-►Tuner is scrolled.
2 Press TUNER again to select the desired waveband.
-►The selected waveband is displayed.
3 Keep <Ki SEARCH or t» SEARCH or ►► on the
remote control) pressed for more than a half second.
-►The selected waveband and Searching are
displayed. The radio tunes to a station with sufficient
signal strength.
2 Keep PROG (PROGRAM on the remote control) pressed for
more than 2 seconds.
-►flutoprograrn is displayed,
prog
and the current
preset number in the music calendar start blinking.
-►All available radio stations for the selected waveband
are stored automatically,
prog
goes off, the preset
number, the waveband and the frequency of the last
preset station are displayed briefly.
• To store radio stations for another waveband, repeat steps
1-2. Make sure to select the next available preset number
first before proceeding, otherwise already programmed
radio stations may be erased.
• To exit the automatic programming, press PROG (PROGRAM
on the remote control).
Note: Strong stations will always automatically be
programmed first, followed by the weak stations.
Manual programming
1 Follow steps 1 and 2 of "Tuning to radio stations".
2 Keep PROG (PROGRAM on the remote control) pressed for
less than 2 seconds.
-►PROG and the current preset number in the music
calendar start flashing.
3 Press <K1 SEARCH or» SEARCH (◄◄ or ►► on the
remote control) to tune to the desired radio station.
• To allocate the radio station to another preset number, rotate
JOG CONTROL (press !◄ or H on the remote control).
4 Press YES to confirm the setting.
-►PROG goes off, the preset number, the waveband and
the frequency of the preset station are displayed.
's)
4 Repeat searching until you find the desired station.
• To tune to a weak station, briefly press < ki
SEARCH or
» SEARCH (◄◄ or ►► on the remote control) as often as
necessary for optimum reception.
|Storing radio stations____________ ____ ____
It is possible to store up to 40 radio stations. Stations can be
selected and programmed automatically or you can do that
yourself. Programming will overwrite your former presets
starting from the last active preset station. After programming
the last stored preset station will be tuned.
Automatic programming
If no preset is tuned, automatic programming starts at preset
number one.
1 Follow steps 1 and 2 of "Tuning to radio stations".
To exit manual programming, press PROG (PROGRAM on
the remote control).
Tuning to preset stations
Use JOG CONTROL (!◄ or ►! on the remote control) until
the preset number of the desired station is displayed.
27