Philips QG3260-41 - Manual (Page 6)

D
Put the hair clipper on Groomer handle
(fig. 4). You will hear a ‘click’.
H Slide the hair clipping comb into the guiding
grooves on both sides of Groomer handle
and push until you hear it ‘click’ into place
(% 5 ).
B Press the Hair Length Setting Selector (1)
and slide it to the desired setting (2) (fig. 6).
See Table 1 for settings.
Q The setting selected will appear on the back
of the Groomer.
When you are clipping for the first time, start
at the maximum clipping length setting (#6) to
familiarize yourself with the appliance and pre­
vent accidentally trimming hairs too short. As you
become familiar with the settings, adjust the Hair
Length Setting Selector to desired trimming length.
Selector will 'click' into position at each setting.
Clipping with hair clipping comb
Table 1. Hair Clipper
Barber Setting Remaining hair length
(in.)/(mm)
#1 1/8 in/3mm
•
3/16 in/5mm
#2 9/32 in/7miTi
#3
3/8 in/9mm
• 7/16 in/limm
#4 1/2 in/13mm
»S 5/8 in/15mm
•
11/16 in/17mm
#6 3/4 in/19mm
B Switch the Groomer ON (fig. 7).
B Make sure that the flat part of the comb is
always in full contact with the scalp to obtain
an even result (fig. 8).
B
Move the appliance slowly over the crown
from different directions to achieve an even
result (fig. 9).
B
Always move the appliance against the
direction of hair growth. Press lightly.
□ Make overlapping passes over the head to
ensure that all hair that should be cut has
been cut.
EE
Turn the Groomer off and remove the hair
clipping comb often to blow and/or shake
out hair that has accumulated.
> REMEMBER:You must reset the hair length
selector back to your desired setting every
time you replace the hair clipping comb on the
appliance.
TlPiWrite down the settings you have used to create
a certain hairstyle as a reminder for future clipping
sessions.