COBY electronic TFDVD1973 - Manual (Page 13)

7
Figure. Cable connections
Antenna/Power Connection
Connect TV RF sources to the antenna port. TV RF signals include: receiving antenna/CATV net. You
1
.
can use 75 Ohm coaxial cable to connect outdoor antenna.
Insert one end of the supplied power cord to the player’s power jack and the other end to the 110-240V
2
.
AC wall outlet.
Compoent Input (Y Cb/Pb Cr/Pr)
The component port is capable of accepting high-definition signals from standard video sources. (e.g., cable/
satellite boxes, DVD players, VCRs, etc.)
Connect the Y/Pb/Pr port by the component cable to input the video signal.
1
.
Connect “R” "L" port by the supplied AV cable to input the audio signal. The red/white plug of the AV
2
.
cable is for the audio conneciton and the yellow plug for the video connection.
S-Video Input
The S-Video port is capable of accepting signals from standard video sources. (e.g., cable/satellite boxes,
DVD players, VCRs, etc.)
Connect the S-Video port by the S-Video cable to input the video signal.
1
.
Connect the AUDIO-L/R port by the supplied AV cable to input the audio signal.
2
.
AV Input
The CVBS port is capable of accepting signals from standard video sources(e.g., cable/satellite boxes, DVD
players, VCRs, etc.)
Connect the VIDEO port with the yellow plug of the the supplied AV cable.
1
.
Connect the L/R port with the red & white plug of the supplied AV cable to input the audio signal.
2
.
VGA Input
The VGA port of the TV is capable of accepting high-definition signals from computers with a VGA output
jack. When used as a computer moniter, connect the VGA jack and the PC Audio In jack with a 15-Pin D-Sub
cable and a 3.5mm stereo audio cable.
HDMI Input
HDMI (High Definition Multimedia Interface) is a new type of connection that transmits digital audio and video
signals simultaneously over a single cable. A HDMI cable is required for the HDMI connection.
These HDMI input connectors are capable of receiving video at resolutions up to 1080p (1080-progressive).
Cable Connections
External AV Source
Set the unit into the relative input mode
to enable the signal pass.