Philips BG2030-60 - Manual (Page 8)

Cleaning and Maintanence
> Clean the Groomer after every use.
I Always switch Groomer OFF and remove cord
from charging stand and charging plug from
outlet before cleaning.
I Never clean, remove or replace shaving head
assembly while motor is on.
I Do not apply pressure to shaving head. Do not
couch foil with hard objects as this may dent or
damage foil or cutters. If damage occurs, replace
damaged parts.
► Do not use Groomer if foil, cutters or trimmers
are damaged or broken as injury may occur.
I Only use the cleaning brush supplied.Any other
brush may cause damage.
I Do not use a towel or cloth to dry shaving foil
or cutters as this may cause damage; allow to
air dry thoroughly.
Never use compressed air, scouring pads.abra»
sive cleaning agents or harsh chemicals to clean
ths^appliaocg.
Note; The trimming ond shoving ottochments do not
need any lubrication.
D
Always switch off the Groomer, remove the
charging plug from outlet and remove cord
from charging stand before cleaning.
□ Remove any comb and/or attachment from
the Groomer.
B Blow and/or shake out any hair that has
accumulated in the trimming attachment
and/or trimming combs.
□ To clean the trimming and shaving
attachments, sec the sections Trimming
attachment' and ’Shaving attachment' below.
B Clean die adaptor with the cleaning brush
or a dry cloth.
Make sure the adaptor does not get
wcl
□ After rinsing, gently shake excess water
from Groomer or attachments. Wipe the
Groomer body dry with a clean towel
or cloth.
Trimming Attachment
D
Put your thumb under the tab to remove
the cover off the trimming attachment
(Fig. II).
B
Rinse the trimming attachment with
lukewarm water.
B
Remove hairs from the inside of the
trimming attachment with the cleaning
brush and/or with lukewarm water (Fig. 12).
a After cleaning, snap the cover back into
the trimming attachment (’click') (Fig. 13).