Clarity ALERTMASTER AL12 - Manual (Page 3)

E
N
G
L
I
S
H
ADDITIONAL SAFETY NOTES FOR CANADIAN USERS
The following items are included as part of the CS-03
Requirements. The standard connecting arrangement for the
equipment is CA11A. This product meets the applicable Industry
Canada technical specifications.
NOTE: The Canadian Department of Communications label
identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective
operational and safety requirements. The Department does
not guarantee that the equipment will operate to the user’s
satisfaction. Before installing this equipment, users should ensure
that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be
installed using an acceptable method of connection. In some cases,
the company’s inside wiring associated with a single line individual
service may be extended by means of a certified connector
assembly (telephone extension cord). The customer should be
aware that compliance with the above conditions may not
prevent degradation of service in some situations. Repairs to
certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to
request the user disconnect the equipment.
Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines and
internal metallic water pipe system, if present, are connected
together. This precaution may be particularly important in rural
areas.
Warning: Users should not attempt to make such connections
themselves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate. The Ringer Equivalent
Number is an indication of the maximum number of terminals
IMPORTANT SAFETY INSTRUCTIONS
allowed to be connected to a telephone interface. The termination
on an interface may consist of any combination of devices subject
only to the requirement that the sum of the Ringer Equivalent
Number of all the devices not exceed five.
IMPORTANT SAFETY INSTRUCTIONS
3 4
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED PERSONNEL.
SAVE THESE INSTRUCTIONS
The lightning flash with arrowhead symbol
inside an equilateral triangle is intended to
alert User that the presence of uninsulated
“hazardous voltage” within the product’s
enclosure, which may be of sufficient
magnitude to induce a risk of electric shock
to persons.
The exclamation mark inside an equilateral
triangle is intended to alert the User of
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the product.
This symbol means that the unit is double
insulated. An earth or ground connection is
not required.