Philips MC-120-37 - Manual (Page 16)

Radio Reception
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Tuning to radio stations
1 Select TUNER source.
TUrCR is displayed briefly
2 Press BAND once or more to select your
waveband.
3 Press down on TUNING ^ or^^ and release
button.
The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: 5ERRCH.
^ If a FM station is received in stereo,
stereo
is
shown.
4 Repeat step 3 if necessary until you find the
desired station.
• To tune to a weak station, press TUNING ^
or^> briefly and repeatedly until you have
found optimal reception.
Automatic programming
Automatic programming will start with a chosen
preset number From this preset number
upwards, former programmed radio stations will
be overridden.The system will only program
stations which are not in the memory already.
Press PRESET A or T ( W or W on the
remote control) to select the preset number
where programming should start.
Note:
- If no preset number is selected, default is preset
(1) and all your presets will be overridden.
Press PROGRAM for more than 2 seconds to
activate programming.
f l u T O is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by AM. The last preset
automatically stored will then be played.
Manual programming
Tune to your desired station (see Tuning to radio
stations).
Press PROGRAM to activate programming.
PROGRAM flashes in the display.
Press PRESET A or ▼ (M or W on the remote
control) to allocate a number from 1 to 40 to
this station.
Press PROGRAM again to confirm the setting.
PROGRAM disappears, the preset number and
the frequency of the preset station are shown.
Repeat the above four steps to store other
stations.
You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
Press PRESET A or T (on the remote control
W or W ) until the desired preset station is
displayed.
16