Chicco Car Seat - Manual (Page 19)

36 37
1 .Position Carrier.rear.facing.on.
vehicle.seat,.with.child.properly.
secured.in.Carrier.
2 .Route Vehicle Belt.under.
both.Belt.Guides,.and.buckle.the.
vehicle.belt.
3 .Tighten Vehicle Belt while.
pushing.Carrier.firmly.into
vehicle.seat..
A tightly rolled towel may be used
under the front edge of the Carrier if
needed for stable, secure installation.
4 .Check Installation:
. a .Level.Line.on.Carrier.MUST..
. . be.LEVEL.with.ground.
. b .Vehicle.belt.MUST.be.TIGHT..
. c .Carrier.MUST.be.STABLE
. . and.secure.
Uninstalling Base
Remove.Carrier.from.Base
1 .Loosen LATCH.by.lifting.the.
LATCH.Release.Lever.and.pulling.
Base.away.from.vehicle.seat.back.
2 .Detach LATCH Connectors.
by.pressing.the.red.button.on.each.
LATCH.Connector,.and.remove.
Base.from.vehicle.
Storing LATCH
Insert LATCH Connectors into
storage pockets.
a .
1 .Pull LATCH Pull Strap.to.
secure.LATCH.Connectors.
2 .Roll LATCH Pull Strap.and.
store.in.Pull.Strap.Storage.Pocket.
NEVER travel with CHILD RESTRAINT unsecured in vehicle.
Passengers may be injured during a sudden stop or crash.
When not using LATCH, the LATCH Connectors and Pull Strap
MUST be stored properly.
1
2
1
a .
2
a .
INSTALLATION WITHOUT BASE
NEVER install CARRIER without Base using a non-locking
ELR vehicle belt. The installation will NOT be secure. Refer to
your vehicle owner’s manual for detailed vehicle belt information.
INSTALLATION USING LATCH
a .
b
2
3 4