Using other functions 10, Using the sleep timer, Dimming the display – Classe Audio VSX-80TXV User Manual
Page 55: Switching the speaker impedance, Resetting the system
Using other functions
10
55
En
Using the sleep timer
The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
•
Press
RECEIVER
then press
SLEEP
repeatedly to set
the sleep time.
• You can check the remaining sleep time at any time
by pressing
SLEEP
once. Pressing repeatedly will
cycle through the sleep options again.
1
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
•
Press
RECEIVER
then press DIMMER repeatedly to
change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8
Ω
with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω
impedance rating. Use
the front panel controls to do this.
•
With the receiver in standby, press
STANDBY/
ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
•
SP 6 OHM
– Use this setting if your speakers are
rated at 6
Ω
.
•
SP 8 OHM
– Use this setting if your speakers are
rated at 8
Ω
or more.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the front panel
TONE
button,
press and hold
STANDBY/ON for about three
seconds.
The display shows
RESET?
.
3
Press the front panel
ENTER
button.
The display shows
RESET OK?
.
4
Press
SYSTEM SETUP
to confirm.
OK
appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Note
1 You can also switch off the sleep timer simply by switching off the receiver.
XM RADIO
ROOM 2
DVR 2
ANALOG
ATT
MIDNIGHT/
LOUDNESS
SB ch
DIMMER
SLEEP
SR+
TV
DVR1
TV CTRL
CD
RECEIVER
TUNER
CD-R
DVD
Off
30 min
60 min
90 min
XM RADIO
ROOM 2
ANALOG
ATT
MIDNIGHT/
LOUDNESS
SB ch
DIMMER
SLEEP
SR+
D ACCESS
DIALOG E
S.RETRIEVER
PHASE
CD
RECEIVER
TUNER
CD-R
VSX-80TXV_KU.book.fm 55 ページ ２００６年３月１４日 火曜日 午後６時６分