Coleman NORTHSTAR 2500A - Manual (Page 6)

6
To Tie On Mantles
WARNING
• Replace any mantle with a hole in it. A hole can cause lantern to overheat
and create a hazard. Never operate lantern without heat shield.
■ Always use genuine Coleman
®
Mantles.
■ Attach MANTLE to BURNER
TUBE AND LOWER MANTLE
SUPPORT. Keep red stripe vertical
and be sure clips engage grooves.
Burner
Tube
Lower
Mantle
Support
■ Twist clips.
■ Twist clips.
■ Light mantle evenly and leave to
burn. Once mantle has been burned
it is very fragile. Be careful not to
touch it with your finger or match.
■ Replace VENTILATOR and
GUARD/GLOBE ASSEMBLY. Position
guard wire into notch in frame.
NOTE: When re-installing globe onto
lantern be sure not to contact mantle
clip. Mantle may be dislodged from
groove.