5 connecting the nb20e or nb25e to the power 3, Nb-25e – Cabletron Systems NB20E User Manual

Page 25

Advertising
background image

INSTALLING THE NB20E OR NB25E BRIDGE

3-5

Figure 3-4

Bridge Front Panel

3.2.5

Connecting The NB20E or NB25E To The Power
Source

When installation of the NB20E/NB25E Bridge is complete and the
switches have been set, connect the bridge to the power source in the
following manner:

1. If you have not already done so, plug the power cord (7, Fig. 3-3) into

the power receptacle (6) located on the rear panel of the bridge.

2. Plug the power cord into a wall receptacle.

3. Turn the power switch, located next to the power receptacle, to the on

position.

4. Observe the status of the ON-LINE, STANDBY, PORT 1 OK and

PORT 2 OK LEDs. These LEDs will flash for approximately 10
seconds as the bridge performs it's internal diagnostics.

When the bridge finishes its internal diagnostics, the LEDs should be

in the following conditions:

•

ON LINE LED lit, indicating that the bridge is receiving power.

•

PORT 1 OK and PORT 2 OK lit, indicating that the ports have
passed the internal loopback test and are now ready for
transmission.

•

STANDBY on or off, depending on the bridge's position in the
Spanning Tree Algorithim.

NB-25E

ETHERNET /IEEE 802.3 BRIDGING UNIT

WITH REMOTE LANVIEW® AND MANAGEMENT

XMT

RCV

CP

POK

PORT

1

2

1

1

0

0

ON LINE

STAND BY

FORWARD

BROADCAST

ROOT

Advertising
This manual is related to the following products: