COBY electronic DVD-958 - Manual (Page 13)

3 VIDEO SETUP PAGE
There are five items in the VIDEO SETUP PAGE. They are VIDEO OUTPUT, TV
MODE, HD MODE, COLOR SETTING, and HDMI SETUP.
3.1 VIDEO OUTPUT
OFF: Set video output to the CVBS (composite video).
YUV: Set video output in analog component video format when the component video
outputs are used.
NOTE: If the video setting differs from the physical video connection, the TV set may
have poor picture. Press [V-MODE] on the remote control repeatedly to switch to an
appropriate video output mode.
3.2 TV MODE
When HDMI is set to OFF and when VIDEO OUTPUT is set to YUV, this item is
available.
PROGRESSIVE: The video will be output in the form of progressive scanning.
INTERLACE: The video will be output in the form of interlaced scanning.
3.3 HD MODE (High Definition Mode)
When HDMI is set to OFF and when VIDEO OUTPUT is set to YUV, this item is
available.
Select a HD mode: OFF, 720p or 1080i.
NOTE: This item requires that your TV support HD input and output.
3.4 COLOR SETTING
3.4.1 SHARPNESS
There are three options (HIGH, MEDIUM and LOW) for you to choose in this item.
3.4.2 BRIGHTNESS, CONTRAST, HUE and SATURATION
Enter these items respectively, use direction key [ ]/[ ] to adjust the value, then
press [ENTER] to confirm it.
3.4.3 GAMMA
There are four options (HIGH, MEDIUM, LOW and NONE) for you to choose in this
item.
3.4.4 LUMA DELAY
There are two options (0T and 1T) for you to choose in this item.
System Setup
-12-