phil&teds verve 2014 - Manual (Page 5)

55
VERVE™/VIBE™
Product Care / Conseils d’entretien / Produktpflege / Cuidado del producto / Productverzorging
IMPORTANT IMPORTANT
• Always load/unload your children on level ground.
• Ensure the brake is engaged during the loading and
unloading of children.
• Care should be taken if the stroller is used on stairs
or escalators.
• Always use the safety strap.
• Excessive wear can reduce effectiveness and safety.
Parts may need lubrication. Inspect essential
components for:
• Fraying - especially webbing straps and safety
harness.
• Wear - locks, snap fasteners, tyres, plastic and
moving parts.
• Safety - locks must not be loose.
Tyres & Tubes
• The valve is car-size. Manually inflate to 20 – 22psi max.
releasing air gives a softer ride but lower pressure reduces
tread life.
• New inner tubes and tyres are generally available (21/4” x
12 1/2” tyre) from your dealer, cycle or specialist wheel
shops. Standard tyre kits can repair punctures.
• A flat tyre can result from grit holding the valve open;
to check: inflate tyre, deflate rapidly, and re-inflate.
• Tyres and tubes are not under warranty. Do not over
inflate. Tyre pressure is affected by heat especially
when inside parked cars.
• Rubber tyres can react with some surfaces (including, but
not limited to, vinyl floor coverings, carpets, synthetic
laminates, parquet and linoleum) and cause stains. Always
stand the stroller on a protective surface when indoors.
For rights & remedies, refer www.philandteds.com/warranty
EVA Tyres
• Tyres are not under warranty.
• The verve™ uses EVA tyres on the front -
these are immune from punctures and eliminate the
need for tube replacements etc.
• With use, the surface of the EVA tyre can show
signs of minor pitting - this is normal for this
material, and this does not affect performance of
the product.