phil&teds kiwi explorer buggy single & double - Manual (Page 5)

Useful Information
Brakes •
The brakes work best when the tires are properly inflated. Always apply both brakes when parking your buggy
.
•
T
o brake, push your foot down on the top of each brake.
The
spring will force and hold it onto the wheel.
•
T
o release the brake, push your foot hard down on the tab at
the inside end of the brake.
Safety wrist strap •
Y
our buggy is very free wheeling so the safety wrist strap should
be worn at all times.
•
T
ake special care when using your buggy in high winds, when
running, climbing stairs, mounting or dismounting escalators, walking down hills or on rough terrain.
•
T
he snap fastener attaches to the footplate to keep buggy folded
when not in use.
Harness & Breastplate The breastplate is padded and features an adjustable 5-point harness.
Always secure your child with the harness.
T
o
fasten:
•
click the 5 buckles into the buckle ends on the breastplate.
•
adjust each strap for a firm fit.
•
thread the straps back through the plastic keepers to lock them in place.
•
adjust the crotch strap to exit the rectangle patch at one of 3 angles.
W
arning: ensure crotch strap is used with the rectangle patch
at all times Swivel wheel auto-lock •
T
o fix the front wheel: turn the black cap on the housing, to match
the small hole on the underside and the pin. It clicks.
•
S
et the wheel to trail straight; the lock clicks into place.
The wheel
is now fixed.
•
Swivel mode: pull the cap outwards and half turn.
The black cap
rests on the pin, letting the wheel swivel.
Layback seat •
U
nzip the gusset inside the sling to recline sleepy children.
•
This position is
not
recommended for newborns who need to lie
flat. Use the newborn wings.
•
Always zip up when using the newborn wings
.
•
Place the older/heavier child in the front seat.
•
Lie the infant in the rear newborn position.
•
S
ecure children with adjusted safety harnesses.
Sibling Fitting
(carry newborn and toddler)
Important: Never use the doubles bar with the Sibling position. Installation •
P
ut the brakes on.
•
Zip the rear sling (RS) to the newborn wings (refer newborn fitting instructions).
•
U
nzip the main sling (MS); but do not release the snap fastener
at each side at the top of MS.
•
Zip each newborn wing to the corresponding zip on MS. Refer diagram.
•
A
ttach the anti-fly straps (at the front of RS) to the H frame
crossbar
, using the ladder locks.
T
ighten.
•
Loop front strap on MS over the footplate.
•
Thread the anti-fly straps on MS through the eyelets on RS; secure to the frame (as before), using the ladder locks.
•
A
ttach the sun hood (as before).
•
A
ttach the clear plastic back (as required) using snap fasteners.
Note that dif
ferent snap positions are used for sibling and
newborn positions.
•
Zip or velcro the hood to the top of the clear back.
Newborn wings onto RS
MS to RS