phil&teds kiwi traveller cot - Manual (Page 2)

Component Check Open the carry bag of your Kiwi T
raveller
TM
and check that you have all
components: •
one Kiwi
T
raveller
TM
•
two thick aluminium pole sets, each of 2 sections
•
four black pre-bent flexi-poles, with four sections joined with shock-cord
•
one inflatable mattress
•
four pegs
•
optional sun/insect mesh
Check that no component appears damaged
.
Pre-assembly Mattress: •
Remove the elastic strap and unfold the mattress. Open the inflation valve, and leave to self inflate. New mat- tresses often require manual inflation too.
2 side poles: •
Assemble each of the two thick aluminium poles. Each is made up of two sections - the thin section is stored within the thick section when not in use.
•
Remove the black plastic bung from the end; remove the thin section inside. Replace bung.
•
Insert the open end of the thin section into the indented end in the thick section.
4 flexi-poles: •
Assemble the four black, pre-bent poles. Each pole is joined with shock- cord.
Align each section with the next;
click and form a smooth curve.
Assembly Side poles: 1
Insert the two side poles into the fabric sleeves running along the top sides of the Kiwi
T
raveller
TM
2
Insert the thin end of each side pole first, and, when poles are fully in- serted, fasten velcro end pieces. These keep the poles in place, which support the top sides of your Kiwi T
raveller
TM
3
Unbuckle the clip on each webbing strap attached to the fabric sleeves at each end of your Kiwi
T
raveller
TM
Flexi-poles: 1
Insert a flexi-pole into each sleeve.
2
Guide all the way through to the other side. Insert each pole end into the outside eyelet on the webbing straps.
3
If you find the pole meets with resistance at a seam, stop and feed the end of the pole gently past the seam. Do not force the pole!
4
Clip buckles together
.
5
Attach two other flexi-poles to the sides of your Kiwi
T
raveller
TM
6
Pass the pole up through the webbing loop located where the mesh sides meet the fabric corner
.
7
Continue, passing the pole through
the webbing loop at the centre of each side.
8
Continue down, passing the pole through the webbing loop on the other end.
9
Guide each pole through the eyelets on the webbing strap, closest to the cot .
10
Place the mattress inside. If not fully self-inflated, manually add air before closing the valve.
Y
our Kiwi T
raveller
TM
is now assembled.
Check that it matches the diagram.
Disassembly 1
Reverse the procedure above.
2
Store in carry bag
3
Ensure your Kiwi
T
raveller
TM
is not
stored damp.
Outside Use
•
Always use pegs to secure Kiwi T
raveller
TM
outdoors.
•
Pass pegs through the middle eyelet on each webbing strap.
•
Attach the optional sun/insect mesh to help protect your child from the elements. Fasten the velcro on the ends of the mesh around the top corners of Kiwi
T
raveller
TM
.
•
Use the carry bag.