phil&teds bebe hs - Manual (Page 3)

ADJUSTING THE SHOULDER HEIGHT
The harness has 2 positions. The straps should go into the slots at, or
the nearest slots above the height of the child’s shoulders. To adjust the
harness, remove each strap by passing it through the slots from the front
to the back of the seat; re-route the straps through the appropriate slots
FITTING YOUR CAR SEAT INTO THE CAR
WARNING: This car seat can only be fitted into the passenger
seat of a car with a lap and diagonal seat belt and no air bag.
THE TYPE OF APPROVED SEAT BELT YOU MUST HAVE
Your child seat can only be installed rearward facing using a lap
and diagonal seat belt in the front or rear passenger seat of the
car.
INSTALLATION
• Push the child seat facing rearward firmly against the backrest
of the car’s seat.
• Route the lap section of the adult safety belt through the lap
belt guides and fasten the car seat belt.
• Place the diagonal belt in the diagonal seat belt guide at the
back of the seat.
•
Take out all the slack in the seat belt, ensuring that there are
no twists or kinks in the seat belt.
THE HANDLE POSITIONS
To adjust the handle from one position to another, pull out both sides of
the handle on the swivel point; rotate the handle forwards or backwards
into the desired position:
The carry handle has four positions:
1 Forward in the car
2 Straight up for carrying
3 Against the car seat for rocking
4 All the way down to support baby for feeding and play
5 Stop rocking
Always ensure that the handle is locked in position and that the harness
is correctly fitted and the buckle fastened before lifting your car seat.
CANOPY ASSEMBLY
1. Attach domes located on the inside of the
sun hood to the outside of the handle.
2. Attach domes located at the back of the
sun hood to the back of the seat.