phil&teds quest - Manual (Page 11)

Instructions
The harness should be adjusted as tightly as possible
without causing discomfort to the child. A loose harness is
dangerous and should be checked each time that you use
the seat.
1. To tighten the harness pull down on the adjustment strap
until the harness is appropriately firm.
Caution!
• Pull on the adjustment straps until the harness lies flat
against the child's body.
• There should never be more than one finger's width
of space between the shoulder straps and the child's
shoulders.
2. The harness is loosened by pulling on both straps at
the same time and pressing down on the harness adjuster
that is located beneath the embroidered word “Press” on
the cover.
3. The harness has 2 positions. The straps should go into
the slots at the height of the child’s shoulders, or the near-
est slots above. To adjust the harness remove each strap
by passing it through the slots from the front to the back of
the seat. Re-route the straps through the appropriate slots.
If the shoulder height is not ok, please re-install the seat.