phil&teds evolution User Manual
Page 19
Advertising
Installation in the vehicle /18
4.3 Installation of Group II for
children 15-25kg.
Please make sure
that lap strap is
worn low down,
so that the pelvis
is firmly engaged.
•
Before the installation, please remove the
belt system of baby car seat (see section 5.1)
(including belt pads, shoulder belt, buckle &
crotch strap jacket (4-L).
•
Put your kid into the baby car seat. Guide car
belt through hook (4-M) and then through the
hole in the corner of the bottom (4-L).
•
Pull the car belt through the hole, and insert it
into the buckle (4-N).
•
Tighten car belt.
Advertising
See also other documents in the category phil&teds Products for children:
- classic v2 (60 pages)
- navigator (legacy model) (58 pages)
- navigator (68 pages)
- verve pre-2014 (58 pages)
- smart (42 pages)
- promenade (76 pages)
- sub4 jogger (28 pages)
- S4 USA & AUS (28 pages)
- vibe 2014 (72 pages)
- peanut (62 pages)
- snug (30 pages)
- vibe (19 pages)
- smart (pre-2013) (49 pages)
- S3 - USA (15 pages)
- sport v2 (13 pages)
- sport v1 (24 pages)
- e3 buggy (24 pages)
- e3 twin buggy (20 pages)
- espresso buggy (4 pages)
- kiwi explorer buggy single & double (6 pages)
- traveller (pre-2013) (43 pages)
- T2 travel cot (12 pages)
- kiwi traveller cot (2 pages)
- highpod (42 pages)
- metoo (22 pages)
- lobster (40 pages)
- airlight (32 pages)
- emotion (32 pages)
- parade (28 pages)
- metro 2014 (32 pages)
- escape 2014 (36 pages)
- metro v2 2009 (42 pages)
- escape v2 2009 (10 pages)
- metro v1 (12 pages)
- escape v1 (12 pages)
- pepe v1 (12 pages)
- alpha (28 pages)
- bebe hs (4 pages)
- bebe (5 pages)
- quest (20 pages)
- optimum (44 pages)
- cocoon genius (26 pages)
- columbus (10 pages)
- tott v1 (8 pages)