Pro Boat PRB08007 - Manual (Page 4)

Blackjack 24 4
EN
Introduction
Pro Boat ® RC models look as good as they perform. Our boats, which include everything from scale sailboats to
fully licensed powerboats, exceed expectations and provide years of radio control fun and excitement. Whether your
passion leads you towards the pure serenity of sailing or the all-out speed of a Deep-V, Pro Boat models fit your taste,
budget and lifestyle. You can count on us to be available any time you need help—the brand is backed by Horizon
Hobby, one of the world’s largest distributors of hobby-grade RC products. The Pro Boat brand will help you turn your
boating passion into a reality, whether you’re new to the hobby or an old pro.
Please read this manual for operation and maintenance instructions.
Register your boat online at www.proboatmodels.com.
Recommended Tools and Materials
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 4mm, 5.5mm, 8mm
• Phillips screwdriver: #1
• Hex wrench: 1.5mm, 2mm, 2.5mm, 3mm
• Clear tape (DYNM0102)
• Pro Boat
® Marine Grease and Gun
• Hook and Loop Tape Set, WP 4pcs
Product Inspection
Carefully remove the boat and radio transmitter from the
box. Inspect the boat for damage.
If you find damage is present, please contact the retailer
where you purchased your boat.
Specifications
Length 24 in (609mm)
Beam (width) 8.75 in (222.2mm)
Hull Material Plastic
Motor Dynamite ® 2000Kv,
Marine
ESC Dynamite 30-amp brushless,
water-cooled
Transmitter ECX ® 2.4GHz Transmitter
Receiver ECX 2.4GHz Receiver,
Water Proof
Batteries 4 AA batteries (sold
separately) are required to
operate the transmitter.
A battery (sold separately) is required to operate the boat.
The ESC will operate with 2–3 Cell (7.4V–11.1V) Li-Po or
6–9 Cell (7.2V–10.8V) Ni-MH/Ni-Cd batteries.
24 in (609mm)
8.75 in
(222.2mm)