Pro Boat PRB2600 - Manual (Page 3)

1. Turn on the transmitter then the receiver and check
for correct operation. Move the right stick on the
transmitter left and right. The rudder should move
relative to the stick movement. (See Figure 3)
2. With the propeller free from any objects, give some
throttle input to ensure that the motor is working. If
everything appears to be functioning correctly, you
are ready to run your boat! If any of these functions
are reversed, change the respective reversing switch
position. (See Figure 4)
Note: If you are transporting the boat, disconnect the
battery from the speed controller and then turn the
radio off until you are ready to run the boat. Once
ready, simply turn the radio on and plug the battery
into the speed controller, making sure that the throttle
stick is in the neutral position. Read the Electronic
Speed Control instructions (included with the boat)
before operating.
Checking the Radio System
1. Make sure that the radio is on and the battery is
plugged into the speed controller and motor.
2. Carefully place the boat in the water. Pilot the boat
at slow speeds, staying close to the shoreline to
ensure that you have good control and that the boat
is functioning correctly.
3. Be certain to avoid all objects in the water.
Once you feel comfortable with the control of
the boat, it is safe to go further from the shore
and at faster speeds.
4. If the boat is losing speed, steer the boat carefully
back to shore. It will be necessary to replace or
recharge the battery before running your boat again.
5. If the boat tends to drift one direction during
operation, adjust the steering trim to compensate.
(See Figure 4)
Testing the Boat in the Water
Before and at the end of each run, make sure that
all screws are tight and that the propeller is free from
any entanglement.
Note: Running the Classic Runabout™ in salt water
could cause parts to corrode. Rinse thoroughly with
fresh water after each use.
If you have any questions concerning the setup or
running of the Classic Runabout, please call the
Horizon Service Center at (877) 504-0233.
Maintenance
Rudder Reversing Switch Throttle Reversing Switch
Forward
Left
On/Off
Right
Reverse
Figure 4
Throttle Trim
Steering Trim