Pro Boat PRB2650 User Manual

Page 3

Advertising
background image





section 1: Boat stand assembly

There.are.4.plywood.boat.stand.pieces..The.2.short.plywood.
pieces.are.the.ends.of.the.boat.stand..

Secure.the.2.long.plywood.pieces.of.the.interlocking.boat.stand.to.
one.end.of.the.short.plywood.pieces..Repeat.with.the.remaining.
short.plywood.pieces.

Secure.the.stand.together.where.each.piece.is.joined.with.epoxy.
or.CA.glue.(not.included).

section : Installing the radio system Batteries (cont.)

section : Installing the wing

section : removing the Canopy

Unscrew.the.2.knurled.hatch-mounting.screws.from.the.rear.of.
the.hatch..Slide.the.front.hatch.retainer.toward.the.rear.of.the.
boat.and.lift.the.hatch.from.the.boat.

section : Installing the radio system Batteries

Receiver Batteries

Remove.the.ten.2.5mm.hex.head.screws.that.secure.the.clear.
Lexan.radio.box.cover.

Remove.the.receiver.battery.holder.and.install.4.AA.alkaline..
batteries.in.the.battery.holder..Note.proper.polarity..

Reinstall.the.battery.holder.into.the.radio.compartment.

Secure.the.radio.box.cover.with.the.six.Phillips.screws..

Transmitter Batteries

Remove.the.transmitter.from.the.box.

Remove.the.battery.cover.on.the.bottom.of.the.transmitter.

Insert.8.AA.alkaline.batteries.into.the.battery.holder..
Note.proper.polarity.

Turn.on.the.transmitter.and.confirm.that.the.LCD.illuminates,.
indicating.proper.installation.of.fully.charged.batteries..

Turn.on.the.receiver.switch.and.move.the.controls..Confirm.that.
all.controls.operate.in.the.proper.direction.and.are.controlled.by.
the.proper.transmitter.input.

Turn.the.transmitter.and.the.receiver.switch.off..To.keep.the.boat.
from.receiving.stray.signals,.the.transmitter.should.be.turned.on.
first,.followed.by.the.receiver..Likewise,.the.receiver.should.be.
turned.off.first,.then.the.transmitter..

Install.the.wing.in.the.direction.shown..

Install.the.four.3mm.x.20mm.hex.head.screws.and.secure.with.
the.four.3mm.nuts..

.Apply.screw.locking.compound.to.the.threads.to.lock.the.nuts..
in.place.

NOTE: The.wing.is.not.intended.to.be.a.handle.

Advertising