Pro Boat PRB2800S User Manual
Page 9
9
EN
Section 9: Troubleshooting Guide
Problem
Possible Cause
Solution
Engine will not start
• Engine is not primed
• Out of fuel
• Improper fuel
• Improper glow plug
• Glow igniter not charged
• Dead glow plug
• Flooded engine
• Put a few drops of fuel into the carburetor venturi
and restart
• Fill fuel tank
• Use 20% Blue Thunder
• Install proper glow plug
• Charge igniter
• Replace
• Remove glow plug, invert boat and engage the
TigerDrive to remove raw fuel from the engine
Engine starts, then dies
• Pressure line blocked or unhooked
• Reset needles to baseline setting
• Connect or replace fuel line
• See Section 6
Engine starts and runs for several
minutes, then dies
• Bad glow plug
• Idle speed set too low
• Improper needle settings
• Glow plug failed due to lean engine setting
• Replace
• See Section 6
• See Section 6
• Richen carburetor settings and replace glow plug