Pro Boat PRB2850 - Manual (Page 4)


• Assembled Blackjack 55 RTR
• JR
® XR3i radio transmitter
• Boat stand
• Rudder (2)

Although the Blackjack ™ 55 comes fully assembled and ready for action, you will need a few additional items
in order to run your boat. You will need the following:
Zenoah ® 2-Cycle Oil (ZEN20001) CA or Epoxy Glue
Flex Shaft Lubrication (PRB0100) Fuel Container
Fuel Pump (HAN155) Gasoline (+87 Octane), Ethanol-ree
12 AA Alkaline Batteries (8 for the transmitter and 4 for the receiver)
In addition to the items needed to run the Blackjack 55, we recommend that you carry the following in your
field box:
Engine Tuning Screwdriver (DYN2775) Clean Towels
Bronze Alloy Propeller (PRB0153) 2mm Hex Wrench
2.5mm Hex Wrench 4mm Hex Wrench
#1 Phillips Screwdriver Small Crescent Wrench
Wax Screw-locking Compound
m 1. There are 4 plywood boat stand pieces. The
2 short plywood pieces are the ends of the boat
stand.
m 2. Secure the 2 long plywood pieces of the
interlocking boat stand to one end of the short
plywood pieces. Repeat with the remaining short
plywood pieces.
m 3. Secure the stand together where each piece is
joined with epoxy or CA glue (not included).
m Unscrew the 2 knurled hatch-mounting screws
from the rear of the hatch. Slide the front hatch
retainer toward the rear of the boat and lift the
hatch from the boat.
Contents
Additional Required Items
Suggested Field Equipment and Supplies
Section 1: Building the Boat Stand
Section 2: Removing the Canopy