Pro Boat PRB3400S - Manual (Page 5)

5
Note: Refer to the radio instructions for specific information on
transmitter setup .
It may be necessary to adjust the throttle trim knob to stop the
propeller from turning while the throttle trigger is in the neutral
position .
Throttle Trim
Adjust the rudder trim knob so that the rudder is centered prior to
operation . You may adjust this control to make the boat run straight
during operation .
Steering Trim
Section 4: Checking the Radio System
Section 3: Adjusting the Transmitter
Ensure the antenna tube is properly placed through the hull . It may
be necessary to slightly pull the antenna wire out to make certain the
radio range is sufficient . Turn the transmitter on, then the receiver . Check for correct operation .
The rudder control arm should move toward the front of the boat when
right input is given . Conversely, when left input is given, the control arm
should move toward the back of the boat .
Left Turn
Left Turn
With the propeller free from any objects, give some throttle input to
ensure that the motor is working . If everything appears to be
functioning correctly, you are ready to run your boat!
Note: If you are transporting your boat, make sure you disconnect
the battery from the speed controller and then turn your
radio off until you are ready to run the boat . Once ready,
simply turn the radio on and plug the battery into the speed
controller, again making sure that the boat is in neutral .
Walk away from the boat . Actuate the rudder to confirm proper control
at least 30 feet from the boat prior to deploying the boat into the water .