Pro Boat PRB3650B - Manual (Page 11)

Instruction Manual
Decoy will not connect
(after binding) to
transmitter Transmitter is too near decoy during
connecting process Move powered transmitter a few feet from decoy,
disconnect and reconnect battery to decoy
Decoy or transmitter is too close to
large metal object, wireless source
or another transmitter Move decoy and transmitter to another location
and attempt connecting again
Decoy battery/transmitter battery
charge is too low Replace/recharge batteries
ESC switch is off Power on ESC switch
Decoy tends to dive in
the water or takes on
water The decoy hull is not completely closed Dry out the decoy and ensure the hatch is fully
closed on the hull before returning the decoy
to the water
Center of gravity is incorrect Move the battery in the hull
Decoy tends to turn one
direction Rudder or rudder trim is not centered Repair rudder or adjust rudder and rudder trim
for straight running when control is at neutral
Rudder does not move Rudder, linkage or servo damage Replace or repair damaged parts and adjust con-
trols
Wire is damaged or connections are
loose Do a check of wires and connections, connect
or replace as needed
Transmitter is not bound correctly Re-bind receiver to the transmitter
BEC (Battery Elimination Circuit) of the
ESC is damaged Replace ESC
ESC switch is off Power on ESC switch
Controls reversed Transmitter settings are reversed Do the Control Direction Test and adjust controls
on transmitter appropriately
Motor overheats Blocked water cooler tubes Clean or replace water tubes
Motor power pulses
then motor loses power ESC uses default soft Low Voltage Cut-
off (LVC) Recharge decoy battery or replace battery that is
no longer performing
Weather conditions might be too cold Postpone until weather is warmer
Battery is old, worn out or damaged Replace battery
Battery C rating might be too small Use recommended battery
11
EN