PS Engineering 116X6 - Manual (Page 5)

PS Engineering, Inc.
IntelliPAX Expansion Unit
200-250-00085 Page 2-1 Rev. 14, Jan. 2012
Section II – Installation
2.1 General Information
The IntelliPAX comes with all necessary hardware for a typical installation. The unit is installed either in
the panel (11606, 11616, 11626) or mounted blindly (11606R, 11616R or 11626R). If panel mounted, it
can be installed near the main unit, or near the passengers. If blind mounted, it can be mounted nearly
anywhere. The 11606R and 11616R volume control for the passengers is factory set for a balanced output,
but can be field adjusted through the holes in the side of the unit.
Installation of the IntelliPAX, using the available wiring and hardware supplied, does not require special
tools or knowledge other than described in 14 CFR 65.81(b) and FAA Advisory Circular 43.13-2B
It is the installer's responsibility to determine the approval basis for this installation. An FAA Form 337,
or other approval may be required. See Appendix B for example of FAA Form 337.
2.2 Unpacking and preliminary inspection
The IntelliPAX was carefully inspected mechanically and thoroughly tested electronically before
shipment. It should be free of electrical or cosmetic defect.
Upon receipt, verify that the parts kit includes the following:
250-250-0000 IntelliPAX Panel Mount Installation Kit
250-250-0001 IntelliPAX Remote Mount Installation Kit
250-250-0000 250-250-0001
Part Number Description 11606 11616 11626 11606R 11616R 11626R 11636R
475-442-0002 #4-40 Machine screws, black 2 2 2
625-003-0001 Soft Touch Knob “D” shaft 1 1 1
575-250-0001 IntelliPAX Faceplate 1 1 1
425-025-0009 25 pin Sub-D connector shell 1 1 1 1 1 1
425-020-5089 Male Crimp Pins 25 25 25 25 25 25
625-025-0001 Connector hood 1 1 1 1 1 1
475-002-0002 Connector Thumbscrews 2 2 2 2 2 2
Also, a PM1000II w/Crew faceplate, P/N 575-002-0002 is included with the intercom expansion units,
Part Numbers 11616, 11616R, 11626, 11626R