PS Engineering PMA9000EX Installation Manual User Manual
PS Engineering Accessories communication
Advertising
Table of contents
Document Outline
- Section I – GENERAL INFORMATION
- Section II - INSTALLATION
- GENERAL INFORMATION
- Unpacking and Preliminary Inspection
- Equipment Installation Procedures
- Cable Harness Wiring
- Intercom wiring
- Marker Beacon Installation
- Adjustments
- Communications Antenna Installation Notes
- PMA9000EX Pin assignments
- Post Installation Checkout
- Unit Installation
- Operational Checkout
- Final Inspection
- Section III OPERATION
- SCOPE
- Power and Fail Safe (1)
- Communications Transmit (XMT) Selection (2)
- COM Audio Selector (3)
- Navaid Audio selection (4)
- Marker Beacon Operation (5)
- Intercom Operation (6)
- EnCoder And Push-Push Switch - ECAPS (8)
- Utility Jack (9)
- Telephone Mode
- Liquid Crystal Display Control
- Secondary Navaid Selection (ADF, DME, AUX)
- Public Address Function
- Section IV – Warranty and Service
- Appendix A – External PTT Hook Up
- Appendix B – PMA9000EX Installation Drawings
- Appendix C – J1 Connector Interconnect
- Appendix D – J2 Connector Interconnect