PS Engineering PMA7000H Installation Manual - Manual (Page 26)

PS Engineering
PMA7000H Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-780-0429 Page 3-7 Rev. 4, Dec 2012
The White lamp, labeled "I," is the Inner marker and has a 3000 Hertz 'dot' tone. The lamp and tone will be
keyed at a rate of six times per second.
The audio from the Marker Beacon Receiver can be heard by selecting the "MKR" push-button switch. To
adjust the volume level, there is a service adjustment located on the top of the unit.
A three-position switch is used to set the receiver sensitivity and to test the indicator lamps. Use "HI" sensi-
tivity initially. This allows you to hear the outer marker beacon about a mile out. Then select the “LO” sen-
sitivity to give you a more accurate location of the Outer Marker. The momentary down switch position is
marker test, labeled "T/M" and illuminates all three lamps simultaneously to assure the lamps (internal and
external) are in working order. TST does not activate MM sense output.
Pressing the marker mode select down (to “T/M”) will cause the marker audio to mute for that beacon. The
next beacon received will re-activate the audio.