PS Engineering PMA8000C Installation Manual User Manual
PS Engineering Accessories communication
Advertising
Table of contents
Document Outline
- Section I – GENERAL INFORMATION
- Section II - INSTALLATION
- GENERAL INFORMATION
- Unpacking and Preliminary Inspection
- Equipment Installation Procedures
- Cable Harness Wiring
- Electrical Noise
- Existing GMA340 Installation
- Power
- Communications Push-to-Talk
- Audio Panel interface
- Transmit Interlock
- Backlighting
- Unswitched inputs
- "Swap" Mode
- Bluetooth Telephone Function
- Public Address Mode
- PA Mute (J2, Pin 12)
- Miscellaneous Logic Output (J2, Pin 18)
- Marker High Sensitivity (J2 Pin 13)
- Intercom wiring
- Marker Beacon Installation
- Adjustments
- Communications Antenna Installation Notes
- PMA8000C Pin assignments
- Wiring Checkout
- Unit Installation
- Operational Checkout
- Final Inspection
- Section III OPERATION
- SCOPE
- Communications Transmit (XMT) Selection (2)
- Audio Selector (4)
- Bluetooth® Telephone
- Speaker Amplifier (5)
- Marker Beacon Operation (9)
- Intercom Operation
- Music Distribution and Music Muting (6)
- This function is not remembered when the audio panel is turned off.
- Utility Jack
- Smart Function Keys (SFK)
- Bluetooth® interface
- Internal Recorder and playback
- Section IV – Warranty and Service
- Appendix A – External PTT Hook Up
- Appendix B – PMA8000C Installation Drawings
- Appendix C – J1 PMA8000C Connector Interconnect
- Appendix D – J2 Connector Interconnect
- Appendix E – Instructions for FAA Form 337 and continuing air
- worthiness
- Appendix F – RTCA DO160D Environmental Qualification Form