PS Engineering PMA8000D Installation Manual - Manual (Page 6)

PS Engineering
PMA8000D Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-890-0304 Page 1-3 Rev. 6, Oct. 2014
1.5 SPECIFICATIONS
TSO COMPLIANCE
Marker Beacon: FAA TSO C35d, Class A ETSO 2C35d
Audio Selector/Intercom: FAA TSO C50c, Class 1a ETSO C50c
APPLICABLE DOCUMENTS: RTCA/DO-214 RTCA/DO-143 RTCA/DO-160D
RTCA/DO-178B DO-254
ENVIRONMENTAL Qualifications: A1D1CABSMXXXXXXZBABATBXXE2XXX
Operating Temperature Range: -15º C to 55ºC
Altitude: Up to 50,000 feet in an non-pressurized area
DIMENSIONS: Height: 1.3 in. (3.3 cm) Width: 6.25 in. (16.9 cm)
Depth behind panel 7.15 in. (18.16 cm)
WEIGHT
PMA8000D Unit
Rack with connectors
1.34 lb. (0.61 kg)
0.51 lb. (0.24 kg)
POWER REQUIREMENTS (Including Internal Lighting):
Voltage: 11 to 33 VDC
Maximum Current: 2.5 Amp (Externally protected by a 5A pull-type break-
er)
Audio Selector Specifications
Audio selector panel input impedance: 510

Input Isolation: -60 dB (min.)
Speaker Muting: -60 dB (min.)
Speaker Output (into 4
) with no clipping
14 VDC:
28 VDC: 3 Watts (min.)
10 Watts (min.)
Receiver Inputs: 9 (COM 1, COM 2, COM 3, NAV 1, NAV 2, ADF,
DME, MKR, AUX)
Unswitched Inputs: 5 (including front jack)
Transmitter Selections: 6 (COM 1, COM 2, COM 3
Com1/2 COM 1/3, COM 2/3)
Speaker Impedance: 4

Headphone Impedance: 150 – 1000

Headphone Output: 38 mW each headset, no clipping <1% THD typical
Microphone Impedance: 150 - 600

Bluetooth Radio (PMA8000D -0304 only) Class 3, FCC ID QOQWT32AE
Intercom Specifications
Intercom Positions: 6 places (with individual IntelliVox® circuits)
Music Inputs: 2, (Independent, Stereo)
Music Muting: >-30 dB "Soft Mute" when COM or intercom active.
Distortion: <1% THD @ 38 mW into 150

Mic Freq. Response, 3 dB: 300 Hz - 6000 Hz
Music Freq. Response, 3 dB: 10 Hz – 26 kHz
MARKER BEACON RECEIVER:
Frequency: 75 MHz Crystal Controlled
Sensitivity:
Low:
High:
Capable of: (preset at factory for field application)
1000
Volts (Hard) (360 to 570 V soft)
200
Volts (Hard) (130 to 200 V soft)
Selectivity: -6 dB at ±10 kHz
-40 dB at ±120 kHz