PULSE ShowerSpas 1019 Aqua Rain - Manual (Page 3)

A
C
E D
1. Remove existing shower head and shower arm.
2. Wrap threads of shower pipe with Teflon tape and/or pipe sealant to ensure no leaks. (Diagram A)
3. Slide escutcheon over threaded shower pipe. (Diagram B)
4. Insert threaded pipe into female wall fitting and tighten securely. Use the diverter body to tighten by hand or pipe
wrench on inlet pipe (nearest the wall, see diagram C). Caution: Do not use shower arm (Diagram D) to tighten.
5. While gently pushing up on connection between Shower arm and top tee to ensure Aqua Rain is level, slide
escutcheon against wall (Diagram E) and secure set screw. (Diagram F) Caution: Do not over-tighten set screw.
6. Insert Rubber washer in shower head and secure shower head to shower arm.
B
F
G
H I J
K L M
1. Hold Adjustable Slide Bar (6) in desired mounting location. Evaluate range of adjustment and potential interference
of handshower hose (15) (Diagram G).
2. Mark wall for two mounting holes. Before drilling ensure no live plumbing could be damaged.
3. Slowly drill 1/4” (6mm) wide by 1” (25mm) deep holes 22 5/8 inch (575mm) apart. Make sure holes are plumb.
IMPORTANT : supplied anchors are for solid surface only i.e. tile, marble etc. If mounting to hollow or fiberglass
wall a different anchor/screw and hole size may be required.
4. Insert wall anchors (10) until flush with wall. Slide top mount (7) over slide bar (Diagram H) and secure with screw
(8) (Diagram I). Slide plastic soap dish (12) (Diagram J) onto slide bar followed by narrow end of tapered nylon sleeve
(11) (Diagram K). Align tab on soap dish with slot on sleeve and push soap dish down until flush. (Diagram L)
5. Slide lower mount (7) over slide bar and secure with screw (8).
6. Press covers (9) into mounts (7) (Diagram M).
7. Place washer (14) in hex head of hose (15) and connect to diverter outlet. Place washer (14) in smooth end of hose
and connect handshower (13). Place handshower into holder.
22 5/8" (575 mm)