PULSE ShowerSpas 1013-GL Kihei II - Manual (Page 5)

5
Kihei GL ShowerSpa Assembly
Some Assembly is Required Prior to Installation.
Slide Bar Assembly
Refer to exploded line drawing for reference.
1. Hold slide bar (4) with grooves facing away from you. Press button on hand shower holder (8) and place onto slide bar (4) with holder fac-
ing you and button on top.
2. With slide bar (4) facing you, align grooves on bracket (5) with grooves on back of slide bar (4). Screw holes on bracket (5) should extend to
left side of bar. Insert bracket (5) until flush with opening. Push cap (6) into slide bar (4) opening. Repeat for other end.
3. Align assembled slide bar with pre-drilled holes on right side of ShowerSpa. Secure with machine screws (10) and lock washers (11).
After ShowerSpa is Mounted to Wall
Attach Hand Shower and Hose
1. Insert rubber washer (12) into hexagon shaped end of hand shower hose (9) and attach to threaded outlet on bottom of ShowerSpa.
DO NOT OVER-TIGHTEN.
2. Insert rubber washer (12) into tapered end of hand shower hose (9) and attach to hand shower (7). DO NOT OVER-TIGHTEN. Insert hand
shower (7) into holder on slide bar (4).
Attach Shower Head
3. Insert rubber washer (12) into showerhead (2) and hand tighten onto the shower arm (3).
4. Insert set screws (17) on the under side of shelf mounts (18). Position glass shelf (16) into shelf mounts (18) and hold in place. Gently tighten
set screws until shelf is secure and does not slip out. DO NOT OVER-TIGHTEN SCREWS.