RED OLPF FRAME - Manual (Page 7)

COPYRIGHT © 2012 RED.COM, INC / 955-0011, Rev-A1 7
OLPF FRAME INSTALLATION INSTRUCTIONS
InsTall The sCrews - Do noT Torque
Install 4 screws and progressively tighten them in an “X”
pattern until finger tight - DO NOT torque at this time.
Torque The sCrews
Use a torque wrench and tighten each screw to 30 in-oz.
If a torque wrench is not available an approximate
torque can be achieved by turning the wrench in a
clockwise direction approximately 30° beyond snug.
(30° is the distance between 12:00 and 1:00 on a
clock face.)
Repeat for each screw in an “X” pattern.
TIghTen The sCrews