Cobra Electronics MR HH300 EU - Manual (Page 14)

Antenna, Wrist Strap
and Belt Clip
Installation
Battery Installation
24 English Nothing comes close to a Cobra ® 25
Belt Clip
Use the Belt Clip to carry your radio around with you.
1. Slide the clip onto your belt.
2. Insert the knob on the back of the
radio into the channel on the back
of the belt clip. You must have the
radio upside-down, as shown,
to insert or remove it from the
belt clip.
3. Once the knob has been inserted
all the way into the belt clip channel,
the radio will swing freely while
being securely retained.
Installation
Battery Installation
•
The radio operates with six high quality AA
alkaline Batteries.
Installing the Batteries
1. Open the battery compartment by turning the
screw anticlockwise 1 ⁄
4
turn.
2. Slide the empty battery tray out of the radio.
3. Align the batteries with the slots in the battery
tray and insert them. Be sure to match the polarity
markings on the batteries with those on the tray.
4. Slide the full battery tray into the radio. Be sure
the seal is in its groove and not pinched between
the tray and the body of the radio.
5. Turn the screw 1 ⁄
4
turn clockwise to lock the
battery tray in place.
CAUTION
The gasket on the base of the battery pack
is essential for the radio to be waterproof.
Be certain that it is not dislodged and that
it fits properly into the radio.
Maintaining the Battery Charge
As you use your radio, the battery power
icon will show the battery power remaining.
When the icon begins to flash, it is time
to change the batteries.
Install Batteries
Waterproof Sealing
Battery Compartment Lock
Slide Belt Clip onto Belt
Insert Knob onto Belt Clip
Secure Radio
Secondar
y Icons
Fully Charged
Partially Charged
Fully Discharged
300-BR-F 6/23/04 1:55 PM Page 24