Sandia Aerospace SAC 7-35 - Manual (Page 26)

The configuration menu presents all the adjustable parameters. To change a parameter enter a single character
followed by return. For example:
Select an Option to Configure: 1
<enter>
Select the number 1 and press Enter. This would change the Port1 Format parameter. The prompt will then
change to:
1. Garmin Z
2. King D
3. Garmin G
4. ADS-B
5. Disabled
Select a Navigation System:
Then enter a selection (or value) followed by enter. For Example:
Select a Navigation System:1
<enter>
The status lines will show the new configuration. (Garmin-Z is represented by a Z):
Serial > Z:1200 G:38400 S:1200 E:19200 Mode>> IAS_Cutoff=40 Arinc=A DASH -00
Trim >> Alt:-1270:1270 IAS:0:10 Baro:-1.27:1.27 OAT:.0:.0 Hdg:000:0
Fuel >> K=130000:500 0s delay 6.02lb/g
After all the configuration parameters are programmed, select x
<enter> to store the parameters. Press
Enter again to record changes or Escape to go back. The status lines should be recorded for future
reference. Then the DIN to Serial cable adapter removed. Upon a power cycle, the new parameters will
be set into the SAC 7-35.
Note: Record and save the Status lines for future
use. They can be use to reprogram the unit should
service or replacement be required.
SAC 7-35 S/N ______________ A/C N# ___________________
Serial > ___ : ________ ___: ________ ___ : ________ ___ : ________ Mode>>IAS_Cutoff= _____ Arinc= ____ DASH _______
Trim >> Alt: ________ : ________ IAS: _____ : _____ Baro: ________ : ________ OAT: _______ : _________ Hdg: _____:________
Fuel>> K = ________________:________________ ________S delay _________________lb/g
25
Note: The SAC 7-35 must be reset by cycling
power, after configuration is completed