Santec 1072XL - Manual (Page 3)

2
- Tighten all nuts and connections to avoid leakage.
- Connect and tighten the Inlet hoses to the supply lines.
- After the connections have been made, turn on the water supply and check for
leakages at all joints. If water leaks from any of the connections tighten the
connection until the leakage stops.
- If no leakage, turn the handles to the full open position and let the water flush for
45 second. This can prevent damages to the ceramic cartridges caused by debris
in the supply line.
INSTALLATION INSTRUCTIONS
PAGE 03
Hot Water Inlet
Cold Water Inlet
1072XX _ _