Santec 1320CA - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4 ” AND MAXIMUM OF 1 1/2 ”
SPOUT INSTALLATION
1
- Remove the tee connector (9), spout mounting hardware (10) and tee connector
washer (11) from the bottom of the spout assembly.
Apply a ring of silicon caulking around the center hole on the top of the sink.
Do not use plumbers' putty which can damage the finish of the faucet.
- From the top of the deck, insert the spout's threaded shank through the center
hole of the sink.
2
- Slip the spout mounting hardware (10) back onto the spout. First the notched rubber
washer and the notched metal washer then the brass lock nut. Tighten the lock
nut. Make sure the lift rod operates smoothly. Adjust it if necessary.
- Place the tee connector washer (11) into the tee connector (9) and thread the tee
connector onto the end of the spout shank. Tighten to seal.
- Align the spout and tighten the shank lock nut (10) firmly.
HANDLE TRIM INSTALLATION
1
- For proper handle turning direction, install the handle with the “cold” blue label (6)
at the right side of the spout (looking from the front) and the handle with the “hot”
red label (5) at the left side of the spout.
- Both hot and cold side handle trims are pre-assembled for faster installation.
- Remove the valve body bottom mounting hardware (12) from the valve body.
Slip the valve body’s flexible hoses from the top of the sink or counter through the
appropriate hole next to the spout. Aim the tee connecting hoses (7) toward
the tee connector (9).
2
- From beneath of the basin or counter, screw the valve body bottom mounting
hardware (12) back onto the valve body. First the fiber washer, then the brass
lock nut.
- Align the handle lever properly against the spout.
Tighten the lock nut until it secures the valve body firmly.
PAGE 02
SANTEC SANTEC
SANTEC SANTEC
Fiber washer
Brass lock nut
1320CA _ _
Notched rubber washer
Notched metal washer
Brass lock nut
Tee connector
Tee connector washer