Santec 2132LS - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate onto the all thread.
- Screw the handle flange with the adapter onto the handle bell.
- Screw the handle bell and flange with the washer onto the all thread.
Press it firmly against the plate and mark the position. Remove the
handle base and cut off the excess thread. Reinsert the handle trim
with the washer onto the all thread and press it firmly against the plate.
- Insert the handle onto the stem. Measure the excess between
the handle bell and the handle. Take off the handle and cut the
excess stem.
- Reinsert the handle onto the stem. Tighten the handle set screw
firmly using the Allen Key.
H H
C C
INSTALLATION INSTRUCTIONS
Lock Nut
Lock Plate
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE
Stem
All Thread
Trim Plate
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN
2132LS _ _
FLANGE ADAPTER